Spinlord Ultra-Seal sealing varnish (20 ml)
Sealing varnish for table tennis blades. It prevents the wood from fraying. This is useful when changing the rubber.
You can check availability and our current prices here. This price only applies to purchases made directly from us. We only deliver to selected countries.
This solvent-free sealing varnish is ideal for table tennis blades.
Sealing the blades is essential to ensure that the rubber can be changed without damaging the wood.
The product comes with printed instructions.
This varnish has a very thin consistency, allowing it to be applied easily and evenly to the blade. Although applying several coats is straightforward, one coat is usually sufficient for the blades we offer (see instructions).
Two sponges are included for applying the varnish. Simply apply the desired amount of varnish to the wood and spread it evenly using the smaller side of the sponge.
20 ml of Ultra Seal sealing varnish is sufficient for at least six bats.
This product has a minimum shelf life of 12 months from the date of purchase when unopened.
Hazard and safety instructions:
Keep out of reach of children. Not for consumption. If swallowed, do not induce vomiting. If the product comes into contact with the eyes, rinse thoroughly with water and seek medical advice if necessary. Contact with the skin is harmless. Only use in well-ventilated areas.
Instructions for use: SpinLord Ultra Seal sealing varnish:
This varnish has a very thin consistency, allowing it to be applied easily and evenly to wood. Applying several coats is also straightforward.
For the woods we offer, one coat on each side is usually sufficient if you only intend to change the inverted rubbers occasionally. However, if you wish to mount rubbers with an adhesive film onto the wood or if you change rubbers more frequently, it may be advisable to apply two coats of varnish, allowing a drying time of at least two hours between each coat. For blades with a very delicate top veneer, such as our Lion Earth DEF model, three coats of varnish may be necessary.
However, if the blanks are already lightly varnished by the manufacturer, under no circumstances should you apply more than one coat of varnish. This applies to our Lion Absolute Intact, Lion Blast series, Lion Carbozone series and SpinLord MIG series blanks.
If the varnish layer is too thin, the wood will not be adequately protected. If the varnish layer is too thick, the rubbers may not adhere properly.
Each coat takes only approx. 2 hours to dry. If you wish to use adhesive films, please allow the final coat to dry for at least 24 hours. The longer you leave the varnish to dry, the easier it will be to remove the adhesive film or rubber later on.
A washable sponge is included for applying the varnish. Simply apply the desired amount of varnish to the wood and spread it evenly using the narrower side of the sponge.
Please ensure that the wood is clean before treatment. Even small dust particles must be removed. After applying the sealant, remove any remaining particles from the wood’s surface before the varnish dries completely.
Seal the bottle immediately after use!